skip to Main Content
Papa Pump - how it works

In 1996, English engineer, Frederick Philip Selwyn, patented a fluid pressure amplifier which revolutionized ram pump technology with a new venturi effect valve.

This Venturi Valve uses the low pressure generated by high velocity water flow around a curve-shaped elastomeric valve (with low pressure loss) enabling rapid closure and with a relatively small cross sectional area and low weight. The Venturi Valve is configured as a ring section positioned around the supply inlet of the pump with the delivery outlet of the pump being directly in line. This allows the pump structure to be concentric and therefore inherently strong. Upon closure of the valve, it permits efficient water delivery by acting in line with the supply via a second smaller venturi effect non return valve in the delivery side. The elastomeric material and operation of these valves allows them to self-return without weight or spring assistance.

This unique technology and design dramatically reduces the weight, manufacturing cost and number of components required - as well as providing an overall improvement in efficiency.

Meet the Inventor

How it Works

Inside the Papa Ram Pump

cross section through the papa ram pump


papa ram pump section 1

Water enters the ram pump through the supply port and flows around the main valve to the exhaust port.

As the flow increases around the main valve, a differential pressure occurs causing the valve to suddenly close. The flow and mass of water is then directed through the non-return valve into the delivery port at a higher pulsed pressure.

papa ram pump section 2

This pressure suddenly reduces causing the main valve to reopen and the cycle repeats.

papa ram pump section 3

Turning the adjuster to open
the valve allows flow through
the pump to be regulated so
that a greater flow generates a
greater pressure and water delivery.

Animation of the  Pumping Cycle

gif animation of a working papa ram pump

Papa ram pumps at work

Water Delivery Principles

For your Papa Pump site to be viable you must have...

A flowing spring, stream or river and the watercourse must fall to give a Supply Head of a least 1m
(The Supply Head is the difference between the highest point of your watercourse and the lowest point across your land)

The greater the Supply Head, the greater the amount of water you can deliver
and the higher you can potentially lift the water.

The main objectives to planning an efficient system is to maximize the Supply Head but to keep the Supply Pipe (between the Supply Tank and the Pump) as short as possible.  You can achieve this by running the Feed Pipe (between the Catchment and the Supply Tank) along the contours of the land as shown below.

Papa Pump Site Principles
Papa Pump Learn More

Assess your Site

how to measure, plan and
install your System

self install icon

Ready to Install?

to plan your


Buy from Amazon

or call +44 1288 354 454

Papa Pump FAQs

Want to know more?

to go to our Fequently Asked Questions Page

Back To Top Water Powered Technologies US